Brewferm Belgian Dubbel Beer Kit

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating

Bad Good

Continue

Instructions for Brewferm® beer kits

Read these instructions carefully and in full before you start. The preparation process is essentially the same for all beer types, but the amounts of sugar and water are different for the various types.
The amounts for each type are shown in the WATER & SUGAR CHART. Brewferm® beer kits are very easy to use. The most important thing is to ensure that everything you use is absolutely clean.

Procedure

1. Remove the lid and the yeast.
2. Open the can and place it in a kettle filled with warm water (+/- 40°C) so the malt extract takes on a more fluid consistency.
3. Pour the contents of the can into your clean fermentation bucket.
4. Rinse the can well with 1 l of warm water and add.
5. Dissolve the amount of SUGAR 1 in 2 l of warm water and add (if SUGAR 1 = 0 grams, just add 2 litres of warm water).
6. Mix everything thoroughly with a clean mash paddle or spoon.
7. Add cold WATER 1 and mix everything again.
8. Let the mixture cool down to approx. 20-25°C.
9. You can measure the specific gravity using a hydrometer if desired. The ideal value is shown on the label (Original Gravity) and in the table below.
10. Open the yeast and pour the contents of the packet out over the liquid.

Fermentation

11. Close the fermentation bucket and place the airlock on it, which you have filled with water to approximately halfway.
12. Set the bucket in a warm place that has as stable a temperature as possible (18–23°C) and leave to ferment for 7-10 days.

Bottling

13. Use a hydrometer to determine the specific gravity. Your beer is ready for bottling if:
• There is no more activity in the fermentation bucket and
• The measured SG is more or less equal to the expected SG (see chart) and
• The SG has been stable for 48 hours
Remark: To measure is to know; if you aren’t sure, wait 48 hours and measure again.
14. Siphon the beer into a clean fermentation bucket without stirring up the sediment.
15. Add 7 grams of sugar per litre to the beer for bottle-conditioned beer (if filling kegs, use 2.5 grams of sugar per litre).
16. Mix well. TIP: Dissolve the sugar in a little warm water and let it cool to room temperature.
17. After filling, seal the bottles with a crown cap or flip-top and keep at room temperature (18-23°C) to get the second fermentation started.
18. After ten days, move the beer to a cooler spot to ripen (6 to 8 weeks).
19. Open your beer, pour it and enjoy! Cheers!

Tips

• Everything must be absolutely clean! Use a cleaning product specifically intended for this purpose, such as Chemipro® OXI or PBW combined with Star San.
• To measure is to know. Each fermentation is a biochemical process, and is not an exact science. Don’t panic if your fermentation values aren’t identical to the values in the chart.

SAFETY PRECAUTIONS:
Observe the following rules to avoid the risk of exploding bottles or kegs:
• Use only pressure-resistant and reusable beer bottles free from scratches and cracks.
• Do not rely solely on a fixed fermentation time or the bubbling of the airlock. Always measure the initial and final density of the beer as described in the user guide.
• Never add too much sugar when bottling.
• During the second fermentation, store bottles and kegs in a separate, closed room, with a stable temperature and preferably not in busy areas.
• Never store filled beer bottles or kegs where they are exposed to direct sunlight.

WATER & SUGAR CHART